Skip to content

Category: Machinery & Systems

Propulsion, running gear, electrical, electronics and the dive-specific systems that keep a liveaboard earning. Engine and gearbox overhaul, cooling and fuel systems, shaft alignment and stern gear, switchboards and battery banks, bonding and stray-current investigation, navigation and communications, and breathing-air compressors and nitrox plant.Most of this work can be done afloat at anchorages around Waisai, the Dampier Strait, Gam, Kri and Misool, which is what allows an operator to base in Raja Ampat and still keep downtime measured in days. The binding constraint is parts lead time, not skill, and these notes explain how to plan around it.

Why Marine AC Dies in the Tropics — and How to Keep It Alive

Why Marine AC Dies in the Tropics — and How to Keep It Alive

Marine air-conditioning fails in the tropics for one dominant reason: the seawater side of the system fouls, flow drops, and compressors cook themselves against condensers that can no longer reject heat into 30°C water that was marginal to begin with. Understand that single mechanism and most of the classic failures — high-pressure trips, short cycling, […]
View Details
Fuel System Troubleshooting: Water, Diesel Bug & Blocked Filters

Fuel System Troubleshooting: Water, Diesel Bug & Blocked Filters

Three enemies live in a boat’s diesel in the tropics — free water, microbial growth, and the sediment both leave behind — and almost every fuel-related breakdown traces to one of them reaching a filter or an injector at the wrong moment. This guide explains how each gets aboard, how to read what you drain […]
View Details
Dive Compressor Air Purity: Testing Standards & Service Intervals

Dive Compressor Air Purity: Testing Standards & Service Intervals

Breathing-air purity on a dive boat is governed by recognised standards — EN 12021 in most of the diving world, with CGA Grade E the common North American reference — and meeting them is not a certificate on a wall but a discipline: filter stacks changed by hours run, quarterly air-quality tests, and a compressor […]
View Details
Marine Generator Troubleshooting at Anchor: A Practical Order

Marine Generator Troubleshooting at Anchor: A Practical Order

When a marine generator will not start or will not hold load at anchor, work the problem in this order: fuel, air, cooling, electrical controls, and only then the machine’s internals — because on generators the humble causes outnumber the expensive ones by ten to one. This is the practical sequence for a liveaboard crew […]
View Details
Shaft Vibration Diagnosis on Liveaboards: From Symptom to Fix

Shaft Vibration Diagnosis on Liveaboards: From Symptom to Fix

Shaft vibration on a liveaboard has five usual suspects — a fouled or damaged propeller, a bent shaft, worn cutless bearings, misalignment between engine and shaft, and failing engine mounts — and the pattern of the vibration usually points to the culprit before any equipment is unbolted. This guide walks the diagnosis in the order […]
View Details
Watermaker Membrane Problems in the Tropics: A Field Guide

Watermaker Membrane Problems in the Tropics: A Field Guide

Most watermaker trouble in the tropics is not the membrane’s fault: low product flow, creeping salinity and pressure problems usually trace back to fouled prefilters, a tired feed pump, or biological growth from bad flushing habits — and the membrane merely takes the blame. This field guide separates the faults a crew can fix at […]
View Details
WhatsApp the desk Email the desk
WhatsApp